Fuel filter separate water 2997378 fuel water separator 2997378

Short Description:

Send email to us

Product Detail

Product Tags

Size

Outer Diameter : 108mm

Height : 216mm

Thread Size : 1-14 UNS

Supplement/Supplementary Information : with seal

OEM

FORD : 3C46-9176-CA

FUCHS : 541 16 57780

HAMM : 01292404

HAMM : 300 129.2404

HITACHI : 263J227001

HITACHI : EOA000557

IVECO : 299 7378

IVECO : 4 255 4067

IVECO : 5041 66113

LIEBHERR : 10101998

MAN : 51.12503-0051

MAN : 51.12503-6000

MANITOU : 608776

MERCEDES-BENZ : 000 477 01 03

MERCEDES-BENZ : 000 477 03 03

MERCEDES-BENZ : 000 477 13 02

MERCEDES-BENZ : A 000 477 01 03

MERCEDES-BENZ : A 000 477 03 03

MERCEDES-BENZ : A 000 477 13 02

OTOKAR : 13C0833116AA

PAUS : 555450

Operation method of air drainage of truck oil-water separator

Oil-water separator exhaust and drainage, also known as: low-pressure oil circuit air intake, oil circuit exhaust air, diesel filter air discharge, fuel filter element water discharge, filter cup water discharge, diesel filter water discharge, diesel grid water discharge, hand oil pump water discharge; vehicle oil input Air, hand oil pump pump oil, etc. Fault phenomenon: the engine is difficult to start, the engine is not running smoothly, it is easy to turn off the engine during driving, and the precipitated water indicator light is on.

The air and pump oil in the high-pressure oil circuit (from the fuel injection pump to the fuel injector) can be removed by the starter motor. Do not loosen the pipe nuts on the fuel pump end, the fuel rail end and the fuel injector end. , to avoid high pressure injury. 2. The air and pump oil in the low-pressure oil circuit (from the fuel tank to the fuel pump pipeline) can be treated by the following methods: 1. Park the vehicle in a safe and flat place, and open the fuel tank cover; 2. , Find the position of the oil-water separator, and unscrew the exhaust bolt on the top of the filter element in a counterclockwise direction (usually a hexagon socket)
Operate the handle of the hand oil pump reciprocatingly for about 30 times until the fuel overflows at the exhaust bolt and there are no air bubbles.
Quickly and carefully tighten the exhaust bolt in a clockwise direction, as shown in step 2. 5. After exhausting the fuel system, start the engine. 6. If the engine does not start within 10 seconds, repeat steps 2 to 4. Oil-water separator drainage treatment method: 7. Find the position of the oil-water separator, and place the container (with a capacity of about 0.2L) under the drain plug of the oil-water separator.8. Carefully loosen the water discharge cock in a counterclockwise direction, and continue to discharge water for about 10 seconds. 9. After the water is drained, tighten the drain cock clockwise, and then inject fuel according to the operations from steps 2 to 4. 10. After starting the engine, check whether the fuel leaks out through the drain cock. At the same time, check whether the fuel filter indicator light is off, if not, repeat the drainage operation process.